FSWERKS Passenger Side Engine Mount - Ford Focus Zetec

SKU: FS046N
  • $159.95
  • 1 review


FSWERKS Passenger Side Engine Mount - Focus 16v Zetec
Billet / Polyurethane Engine Mounts

The Ford Focus factory engine mounts were designed as soft, flexible units, to provide a comfortable drive. The drawback was the relatively large amount of engine movement the OEM mounts allowed under torque load and on hard acceleration. Such engine movement decreases stability under high performance driving conditions and rapid gear selection.

To reduce this movement FSWERKS engineered a complete fitted replacement with specially shaped molded, 70A durometer polyurethane inserts. The mount body is machined from billet aircraft grade aluminum, being almost twice as strong than the OE cast material. Installation should take no more than 10-15 minutes. This high performance mount provides a difference in the stability of the car when accelerating and braking hard. Gear changing under hard acceleration is also enhanced.

NOTE: For street use, we recommend using only the rear engine mount. Using all mounts together will cause some vibration (due to the nature of performance polyurethane mounts) that may not be desired for a daily driver, and is more for track use (Road racing, drag racing, autocross, etc).

Torque Specifications: (59ft lbs) two nuts to engine block, (38ft lbs) center engine mount bolt/nut
Note: Support engine/transmission during installation

Fitment:
Ford Focus Zetec 2000 2001 2002 2003 2004


Customer Reviews
5.0 Based on 1 Reviews
5 ★
100% 
1
4 ★
0% 
0
3 ★
0% 
0
2 ★
0% 
0
1 ★
0% 
0
Write a Review

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
07/29/2024

Big difference

I now have all 3 poly mounts and I can say by far that this one will make you notice a big difference. All 3 mounts give you a different feel. But this mount paired with the other two stiffened up and made me feel more connected to the car. Solid motor now and couldn’t be happier. Only problem I had was the holes the studs on the head go through on the mount. Either my studs were bent or the machining on the mount holes are off because they weren’t exactly centered and I had to force/interference fit the mount over my studs and there’s no way to tell how straight the mount is on the mounting bracket, kinda just have to eyeball it. But other than that it works great and was an easy easy install.

DG
Devan G.
United States United States